.310 Cadet Front Sight
I was just given a Cadet barrel that is in excellent condition with sharp rifling. The problem is that someone cut the front sight off. I have an old barrel with a good front sight and would replace...
View ArticleRe: .310 Cadet Front Sight
Soft soldered in the dove tail,just add a little heat and tap out,Lock tight will work to hold it in place
View ArticleRe: .310 Cadet Front Sight
Update:I heated the cut-off sight on the good barrel plenty hot enough to soften soft solder and still could not drive the sight off from either side. I then put the bad barrel with the good sight in...
View ArticleRe: .310 Cadet Front Sight
Strange ,I have replaced a few barrels and removed the old sights quite easily using just a little heat and a drift.What make of barrel do you have
View ArticleRe: .310 Cadet Front Sight
Red heat should melt silver solder and this was tyred,the ones I removed(heated the sight not the barrel) did not need any were near this heat to melt the solder.All the ones I removed(Greener and...
View Article
More Pages to Explore .....